Нижній обтекатель

Molding quality and texture is fairly good its to be expected from fiberglass resin made. I like the fact it comes with all the mounting hardware which makes installation easy. The blue markings i made on the product are areas i need to grind or cut off due to my exhaust set up which i am very aware of before purchasing it, i knew i would be modifying it to make it fit. Product was well packaged and protected. I would advice anyone who purchase this cowl to be aware of what type of exhaust set up you have and be prepared for minor modification but if your a Do It Yourself like myself, it shouldn't be difficult to work around modifying it. On a side note you will need to paint it with the color of your choice as well.

Satisfied with Total first.
I am satisfied with the Refreshing look of the lower part of the Engine.
I think it can be installed in NORMAL condition.
Brake pedal may interfere a little. (I think it depends on the individual)
Installation was rather easy with Bracket.
Next is the Cowl Mounting Bolt. In my case, I was concerned about the directness of the bolt, so I purchased KITACO's Nylon washer separately and tightened it.
However, over, GP-PERFORMANCE Full Titaniumium Full Exhaust Muffler interferes with it, so a small modification is required. (This shape same type may interfere) Also, GCraft's "Chikki-kun" (a small, sturdy, and strong machine) also needs to be processed.
I have attached a photo for your reference.
I processed it myself with BabyGrinder, so it doesn't look great! (TT) If you have a regulation such as Race, you may need to be careful because the Exhaust System part has been cut off. I was shaving it off for the purpose of dress-up. I had expected that.
The painting was done with Holtz's Luster Erase Black and Luster Erase Clear, but it was my first attempt at painting and I hid the failed areas with Sticker. (Chuckles) I noticed some spots on the bottom coat of Black, but it was too late, so I continued on with it, but we'll see what happens. If it comes off, I will have to reapply. I'm sure you all do a good job of prepping your work, but since it was a gel coat, you shouldn't cut corners just because you think it's good.
The Spray I bought this time is used up, so I'll see how it goes and if it doesn't work, I'll probably repaint it.
The value is also there, so I would like to request that the mussels be kept after the Gel coat is painted, even if only temporarily.
I'm looking at this from a beginner's perspective, so some mistakes may be unavoidable.
I also think Large sturdy because you all don't cut corners.
After a short run at the end, the lower part of the Under Cowl was warm and the heat from the exhaust pipe was transmitted. There was a gap of more than half a finger and less than one finger, which is a little worrisome. It depends on the future.

[How is it used?
It's nice to cut the wind.
Was the one you received as per Image?
Street Image
Was the installation difficult?
There was no Instruction Manual, so I was a little worried.
How was your experience with it?
Custom look
[Included Parts:were they on?
It comes with Bolt and Bracket
[Was there anything that disappointed you?
I want the Instruction Manual to come with it, just a sheet of paper.
Other items that would be helpful
No Instruction Manual/Request Instruction Manual is attached.