- MT-09 (The '14.) For the front up of (It's a low rating.) I bought it as a no-goI assembled it with reference to the parts drawing and lifted it up fearlessly Can you use it properly?I think it's basi...Детальніше
- as for Front or for Rear, depending on the conditions … the placeIn our environment (CBR250RR and X11)i feel LimitOut as it is both for Front and for Rear It's a pityas for Front, it cannot be used to...Детальніше
- Since I am a maintenance beginner, when I first used it, I was pretty worried because I would beat Motorcycle Body, but once I grab hang, I could easily raise both Rear and Front!Детальніше
- Drawing difficult to see translation (Please do not enter here. I ordered a certain famous thing immediately after using it. I immediately removed it from my favorite car It was a loss of cheap buying...Детальніше
- You had better quit dual use.I can still use Rear, but Front does not feel like going up.Forcibly raised Motorcycle collapsed.On the contrary it was expensive shopping.After all, I replaced a famous M...Детальніше
- Compatibility with air-cooled Kawasaki ◎?Assembled for 3 minutes, with Center Stand combined, heavyweight cars got a little up in one handMaintenance efficiency Up mistake ♪Детальніше
- I think that the price and the commodity are like this if only once. After opening the stage Ball, it was in the state of RoseRose. But the price was also cheaper and it was a product. But it was good...Детальніше
- I bought it for GSX-R 750 and WR 250 X, but it was short in the back, I was disappointed without getting stuck in front.First, the back is 17 Inch wheel but avoiding Axle Shaft is difficult to make it...Детальніше
- I bought it to lift the Front of HORNET.I think that Rear stand is essential as it will become Front up after lifting Rear.In the case of HORNET, it seems to be in contact with Front fender when insta...Детальніше
- You can make it cheaply.When I use it for Rear stands, I feel that I want a bit more height in my MotorcycleEven if you shake it during use it is a nice feeling without anxiety.Детальніше
- There was only an assembly drawing, but I was lost as to how to use itUnder bracket Because Arm inserted under is FreeI will only raise it after plugging in.It got so light as I was beat fast.Детальніше
- First of all, packing was good, but since the width of Pipe used for Front did not match at the time of assembly, it was multiplied by force technique and weight. Next, when the rod to be inserted in ...Детальніше
- When it is used for for Front, assembly is a little troublesome, but basically it is easy to use.I think that use of daily Maintenance etc. is sufficient.Детальніше
- "Front maintenance stand" in Maintenance around Front was Items I want.The product is evaluated for its price and comment etc. I did not expect so much - - It is quite good, is not it?. I do...Детальніше
- It will become the first STAND,For the time being to buy Rear, I bought it for now.After arrival, it was a little Large strange that a part had a large amount of Grease? And adhered to others and wipe...Детальніше
- Because I had for Rear, this price was somehow acceptable and so purchased as for Front.You can do Front up neatly. I used it to install Adjuster, but I do not interfere with Fender, I think that it i...Детальніше
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING