* Цей виріб приблизно на 65 мм назад і на 3 мм нижче у висоту, ніж ручка для скла.
* Загальна ширина -5 мм на кінці важеля запасу. (Загальна ширина: ± 20 мм / загальна висота: ± 40 мм) Ніяких структурних змін не потрібно.
* Не потрібно міняти шланг / джгут / провід для цього виробу, але якщо вас це турбує, будь ласка, змініть гальмівний шланг на відповідну довжину. Будь ласка, відрегулюйте натяг дроту осі через зміну керування.
* Існує помилка в товщині фарби на цьому виробі. Коли ви повертаєте сторону осі, вона може бути нудною. У цьому випадку необхідно відрегулювати сторону втулки дросельної заслінки за допомогою гоління пилкою.
* Штампувальні знаки на цьому виробі служать лише для ознайомлення. Будь ласка, налаштуйте положення ручки на свій смак.
* Є випадок, що отвір у розподільній коробці цього виробу злегка вирівнюється. У такому випадку може знадобитися змінити його, розширивши отвір. Якщо ви - людина, яка до роздумів ставиться до болтової установки, або вас турбують витрати праці та процес, радимо заздалегідь проконсультуватися з магазином Honda Dream.
* Зверніть увагу, що специфікація продукту може змінитися через причини виробника.
[Size*] W: 710 H: 100 R: 200 L: 130
[Handle diameter] 1 inch (25.4mm)
*W (Overall width) H (Height) R (Amount of pullback) L (Clamp section straight) Unit (mm)
*This product is approximately 65mm back and 3mm lower in height than the stock handle.
*Overall width is -5mm at the end of the stock lever.(Full width: ±20mm / height: ±40mm) No structural changes are required.
*This product does not require any changes to the hoses / harnesses / wires, but if you are concerned, please change the brake hoses to an appropriate length.Adjust the tension of the axle wire due to the changes in handling.
*The thickness of the paint on this product may vary.There may be a dullness when turning to the axle side.In this case, it is necessary to adjust the throttle sleeve side of the handlebar by shaving with a file.
*The punch marks on this product are for reference only.Please adjust the position of the handlebar to your liking.
*The holes in the switch box of this product may be slightly out of alignment.In this case, it is necessary to widen the hole.If you are a person who is finicky about bolt-on installation, or if you are nervous about the labor cost and process, it is recommended that you consult with your HONDA Dream shop beforehand.
*There may be changes in product specifications due to the manufacturer's reasons.