Це Kit Bracket's, щоб видалити задній фіндер OEM і встановити номер ліцензії.
На додаток до звичайного комплекту DIO Fender Eliminator Kit, Type 2 - Lineup.
Кількість: Пара (для лівого та правого) Лінійний кронштейн розділений на тип 1 (Звичайний товар) Незважаючи на те, що це була особливість типу 2, простою буде номер ліцензійного кронштейну з Центру.
Кут ліцензійної пластини також встановлюється як Спец., І це відповідає також транспортним засобам, перетворені в Lowdown або Long Wheel Base.
● Низька, довга колісна база також підтримує автомобіль
Цей комплект позбавляє бічну частину і встановлює номер ліцензії в простій.
Звичайний тип (Тип1) У порівнянні з кутом ліцензійної панелі, це комплект Fender Eliminator Kit, який також підтримує формування довгого колеса та Lowdown.
Я приймаю багато дозвільної документації між ліцензійною та задньою шиною.
Під час встановлення комплексу Long Wheel Base Kit DIO можна встановити лише цей тип 2.
Звичайний тип 1 Fender Eliminator Kit не може бути встановлений одночасно з комплектом Long Kit Wheel.
● Світлодіодні ліцензійні лампочки з кронштейном Reflector OEM 's License Plate Light також є світлодіодним індикатором, але оскільки це мене занепокоєть за відставання позаду, він поставляється з тонкими світлодіодними ліхтариковими лампами.
Таким чином, воно стає ще більш расистським стилем Ish, не занепокоєння великим розміром ліцензійного світла.
Також рефлекторний кронштейн також є окремим типом, а не тільки для встановлення відбивача ОЕМ, а також для індивідуальної інсталяції іншої фірми ProductReflector установки тощо.
Я також встановив комплект з Slim Reflector.
This kit is for removing the stock rear fender and installing the license plate.
In addition to the conventional Adio fender eliminator Kit, Type 2 is also available.
Type 2 has a simple license plate bracket from the center, whereas Type 1 has a license plate bracket from the left and right.
The angle of the license plate is set more low, so it can be used for vehicles with lowered or long wheelbase.
●Also compatible with low-down and long-wheel custom vehicles
This is a simple kit to install the license plate without side bracket.
This is a fender eliminator kit that has a more angled license plate compared to the conventional type (Type 1), and can be used for lowering the vehicle.
There is a lot of clearance between the license plate and the rear tire.
When ADIO long wheelbase kit is installed, only this type 2 can be installed.
The conventional Type 1 fender eliminator Kit cannot be installed together with the Long Wheel Base Kit.
●LED license plate light and the stock license plate light including reflector bracket are LED, but it sticks out from the back of the vehicle.
This gives the vehicle an even more race-like look without worrying about the size of the license plate lights.
In addition, the reflector bracket is a separate type, so it is possible to install a stock reflector and also to install an aftermarket reflector for customization.
A kit with slim reflector is also available.