[Специфікація]
Номінальна напруга : DC12V
Розмір зовнішнього діаметра : W25,5 мм х H30,5 мм x D15,5 мм (* За винятком виступів)
[Зміст продукту]
Тіло x1pc
Двостороння стрічка x2pcs. (1мм товщина / 2мм товщина 1шт / кожна) (* Під час налаштування, використовуйте 1 аркуш як тимчасову фіксацію.)
Інструкція з експлуатації / Гарантійний талон
* При установці по загальному предмету, PG-110 або PG-220, що продаються окремо, вимагається відповідно до встановлених транспортних засобів.
Зверніть увагу, що ми не беремо на себе жодної відповідальності за будь-які збитки, такі як невдалі або нещасні випадки, пов'язані з використанням цього продукту.
[Specification]
・Rated voltage: DC12V
・Outer diameter dimension: W25.5mm x H30.5mm x D15.5mm (*excluding protruding parts)
[Components]
・Main unit x 1
・Double-sided tape x 2 (1mm thick, 2mm thick, 1 each) (*Use 1 tape for temporary fixing during setting.)
・Instruction manual
*This product is for 12V motorcycles (battery-powered vehicles) only.
*This product cannot be installed on vehicles with point ignition type.The high voltage generated when the key is turned from ON to OFF may short-circuit the SPI unit and cause a failure.(Ex) HONDA CB400FOUR
In the case of HONDA CB400FOUR, there is a case that SPI was short-circuited because 65V (+20V, -45V) were generated at the moment when the key was turned from ON to OFF.
*This product is only for motorcycles with electric speedometers.When installing on a mechanical speedometer (meter cable type), please purchase the optional pulse generator PG-110.
*When the clutch is depressed while driving, the display shows a gear other than the one in which the clutch is engaged, but this is not a malfunction.
*Prioritize safety while driving and do not be careless in front.
*Please do not use non-resistive spark plugs.If you use a plug without resistance, noise may be generated and the rotation signal may not be input correctly, so please use a spark plug with resistance.
*Please put the attached double-sided tape on the back side of this product to prevent water from entering because there is a switch.
*Install the product correctly according to the instruction manual.Improper installation may result in fire or equipment damage.
*After installing this product, periodically inspect it to see if any parts have fallen off.
*PROTEC is not responsible for any damage or accident caused by the use of this product.
*Protec is not responsible for any labor charges for removal or other expenses incurred during repair.
*All vehicles that have been tested by Protec are stock.There is a possibility that a problem may occur if the vehicle is equipped with aftermarket parts other than stock parts.
*This product can be used for vehicles that are not listed in the compatibility information below.Please refer to the list for the required parts.
*Please refer to the service manual of your motorcycle to confirm the respective wiring before installation.
*Some Harley-Davidson [TC96 '05] injection models do not work with SPI.If you are planning to install the product, please contact PROTEC before purchase.
*For other Harley-Davidson models, it can be installed on with the SPI-110 and optional PG-110 + PG-220.